Skip to content
Archery Insider

Vortex Crossfire II 2-7x32 Review: Crossbow Scope Verdict

Vortex Crossfire II 2-7x32 review: the XBR-2 reticle, its 275–450 fps speed ring, sight-in steps, the VIP warranty and how it compares with Hawke and TenPoint.

By

· 9 min read

Research-based: built from maker specs and official sources, fact-checked before publishing. How we review products

View through a low-power riflescope's plain crosshair across a snowy clearing in bare winter woodland
The view through a 4x riflescope with a plain crosshair in snowy woodland. It's a stock photo of a scope's sight picture, not the Vortex Crossfire II, whose XBR-2 reticle adds marks from 20 to 100 yards.Photo: Captaindan at English Wikipedia

This Vortex Crossfire II 2-7x32 review covers Vortex's only current crossbow scope, sold as a kit (SKU CF2-CB1) with 30mm rings, flip caps and a neoprene cover. Our short verdict: a sensible, well-documented choice for crossbows shooting 275 to 450 fps, if you're happy to leave the magnification ring parked at your speed setting. Amazon lists the same Vortex Crossfire II 2-7x32 crossbow scope kit.

Vortex Crossfire II 2-7x32 crossbow scope

Advantages

  • Rings, flip caps and a cover in the box, so it's ready to mount
  • Clear speed table on the magnification ring, 275 to 450 fps
  • Red or green illumination with variable brightness
  • Vortex's unlimited, unconditional lifetime VIP warranty

Trade-offs

  • Magnification is fixed once you set your speed
  • Nothing for crossbows above 450 fps
  • 2.7 in eye relief, shorter than Hawke's 4 in on its 2-7x32

Vortex Crossfire II 2-7x32 specs

These are Vortex's figures from the product page and manual.

SpecVortex's listing
Magnification / objective2–7x / 32 mm
Focal planeSecond
ReticleXBR-2 (MOA), red or green illumination
Tube30mm
Eye relief2.7 in
Field of view at 100 yd57.5–16.4 ft
Clicks / travel per turn1/2 MOA / 30 MOA
Max elevation and windage160 MOA each
ParallaxFixed at 75 yards
Length / weight9.5 in / 14.0 oz
RingsTwo 30mm, 1.1 in (28 mm) high
Original spec card for the Vortex Crossfire II 2-7x32 crossbow scope kit: 2-7x32 second focal plane optics on a 30mm tube, XBR-2 reticle with a 40-yard zero and aim points from 20 to 100 yards, red or green illumination, speed ring marked 275 to 450 fps from 2x to 6x, half-MOA capped turrets, 9.5 inches and 14.0 oz, with a schematic scope and simplified reticle
Our spec card for the Vortex Crossfire II 2-7x32 crossbow kit, built from Vortex's product page and manual. The scope and reticle are schematics, not product photos.Diagram: Archery Insider

Design and features

The XBR-2 reticle and its aim points

Vortex's manual says the XBR-2 "can be used for targets ranging from 20-100 yards and is designed for a 40-yard zero on the center crosshair." The reticle drawing shows where each mark sits, measured in MOA from the centre at the highest magnification:

MarkShapeDistance from centre
20 ydBar above centre17.19 MOA up
30 ydBar above centre10.19 MOA up
40 ydCentre crosshairZero
50 / 60 ydBars below centre11.27 / 23.4 MOA down
70 / 80 ydDots35.88 / 49.19 MOA down
90 / 100 ydDots62.61 / 76.5 MOA down

Close shots use marks above the crosshair, the reverse of reticles that put a 20-yard zero at the top. Our crossbow scope sight-in guide explains both layouts.

The speed ring

On a second focal plane scope the reticle stays the same size while the target grows, so the zoom changes how far apart the marks fall on the target. Vortex uses that to match the marks to your crossbow's trajectory:

MagnificationSpeed
2x275 fps
3x330 fps
4x380 fps
5x425 fps
6x450 fps

Vortex is blunt about it: the scope "must be set to the magnification that aligns with your crossbow's FPS setting for the yardage marks in the XBR-2 reticle to be accurate." Gordy Krahn's 2021 write-up for Archery Business makes the same point, noting the marks are accurate "at 4X for a 380 fps crossbow." The 7x setting has no speed listed; the manual uses it for focusing, mounting and the final 40-yard sight-in.

Illumination, glass and parallax

Turn the illumination knob either way to switch it on and keep turning for brightness; the "R" and "G" off positions sit between the colours. Vortex lists fully multi-coated lenses, nitrogen purging and O-ring seals. Parallax is fixed at 75 yards, and Vortex warns of "small amounts of parallax error" at other distances if your eye is off-centre, so keep your eye centred behind the eyepiece, as the manual advises for the close sight-in shots.

The VIP warranty

Vortex says that if the product "becomes damaged or defective, we'll repair or replace it at no charge," regardless of "how it happened, whose fault it was, or where you purchased it." It excludes "loss, theft, deliberate damage, or cosmetic damage" that doesn't affect performance.

Mounting and sight-in, step by step

Vortex's manual covers mounting in four steps:

  1. Fit the bottom ring halves, lay the scope in them and loosely fit the tops.
  2. Set 7x and slide the scope fore and aft for a full, clear sight picture.
  3. Level the reticle without moving it fore and aft, using a bubble level, feeler gauges or a plumb bob.
  4. Torque the screws. Vortex suggests 15–18 in-lb on the ring screws and 30 in-lb on the base clamps, with no thread locker on the ring screws.

Then the sight-in:

  1. Focus the reticle. At 7x, turn the eyepiece until the reticle blurs, then back in short glances at a white wall or sky until it's sharp straight away.
  2. Shoot at 6 yards at 2x–4x, and move the crosshair to the hole with the turrets. Each 1/2 MOA click is about half an inch at 100 yards, or roughly 0.2 in at 40 yards.
  3. Move to 40 yards at 7x, shoot, adjust and confirm.
  4. Set the ring to your speed.
  5. Reindex the turrets: remove the cap, loosen the centre screw while holding the dial, line up the zero and retighten.

Common mistakes: over-torqued rings, which Vortex links to erratic impacts; forgetting step 4; and dialling the wrong way (if you hit high, dial down).

Which crossbows and speeds it suits

Start with your crossbow's real speed with your hunting bolts, not the box figure. Two examples:

  • CenterPoint Sniper Elite 385: rated 385 fps, just past Vortex's 4x setting.
  • Ravin R29X: rated 450 fps, the very top of the table, and one published chronograph test measured 458 fps. It comes with Ravin's own illuminated scope.

Between printed speeds, Vortex gives no guidance, so this is our suggestion. Say your chronograph averages 400 fps over several shots: that falls between 4x (380) and 5x (425). Set the ring part way between them, shoot at 50 and 60 yards, and nudge it until those marks hit.

Check the 1.1 in rings clear your crossbow's rail and cocking device before you hunt, and check your state's rules on optics and illuminated reticles; our guide to crossbow hunting laws is a starting point.

How it compares

Crossfire II 2-7x32 CrossbowCrossfire II 2-7x32 RimfireHawke XB30 2-7x32 SRTenPoint RangeMaster 100
UseCrossbowRimfire riflesCrossbowCrossbow
Tube30mm1 in30mm30mm
ReticleXBR-2, 20–100 ydV-PlexXB30 SRDots, crosshairs, chevrons, 20–100 yd
Speed range275–450 fpsn/a280–440 fpsUp to 505 fps
Eye relief2.7 in3.9 in4 inNot listed
Weight14.0 oz13.9 oz14.4 ozNot listed
Rings includedYesNoNot in box listNot listed

Vortex Crossfire II 2-7x32 vs Rimfire and Scout

Beyond the table, the Rimfire (CF2-31001R) has 1/4 MOA clicks and parallax set at 50 yards. The Scout Scope (CF2-31002) has 9.5 in of eye relief for forward mounting on scout rifles. Neither has crossbow aim points or a speed scale.

Hawke XB30 2-7x32 SR

Hawke's closest rival lists 280–440 fps, five-level red and green illumination, a "locking speed adjuster", parallax at 50 yards, 4 in of eye relief and more travel (215 MOA elevation). Its box list has no rings, and Vortex's manual describes no lock on its own ring.

Chart of calibrated speed ranges: Vortex Crossfire II 2-7x32 crossbow scope 275 to 450 fps from 2x to 6x; Hawke XB30 Pro 215 to 450 fps, XB30 Compact 1.5-6x36 250 to 450, XB30 2-7x32 280 to 440, XB1 250 to 425, XB 3x32 fixed at 340, and XB30 Zoom FFP in three versions for 385 to 420, 425 to 465 and 470 to 510 fps
Calibrated speed ranges from Vortex's and Hawke's pages and manuals. The orange bar is the Crossfire II's 275 to 450 fps ring; Hawke's XB30 2-7x32 covers 280 to 440 fps.Diagram: Archery Insider

TenPoint RangeMaster 100

TenPoint's scope, per Lancaster Archery's listing, handles crossbows "up to 505 FPS" with lit dots for 20–40 yards, crosshairs for 50–70 and chevrons for 80–100, in red or green. Pick it if your crossbow outruns the Vortex.

What other reviewers found

Dave Chesson of Gun University reports about six months' use: the scope kept working after he knocked it against a tree trunk, and in drizzle and fog it "didn't fog up or get waterlogged." His complaint: "the reticle numbers are small," which made ranging harder in low light. His spec list doesn't match Vortex's figures for this kit; its field of view is the Rimfire model's.

Who should buy it, and who shouldn't

Good fits: replacing a basic package scope on a mid-speed crossbow, with rings and covers in one box.

Look elsewhere if your crossbow tops 450 fps or you'd rather range with the scope itself; our guide to rangefinding crossbow scopes covers that option.

Where to buy

Crossbows shooting 275 to 450 fps

Vortex Crossfire II 2-7x32 Crossbow Scope Kit

Vortex's crossbow kit, model CF2-CB1, with rings, flip caps and a neoprene cover. Confirm your crossbow's measured speed first.

Reticle
XBR-2 (MOA), red or green
Zero
40 yards, centre crosshair
Speed range
275–450 fps (2x to 6x)
Tube / rings
30mm, two rings included

Specifications: Vortex Optics product page and manual

Vortex's warranty applies wherever you buy.

Frequently asked questions

What is the difference between the Crossfire II 2-7x32 crossbow and rimfire scopes?

The crossbow kit has a 30mm tube, the XBR-2 reticle, red or green illumination, a speed scale on the magnification ring and rings in the box. The Rimfire model has a 1-inch tube, a plain V-Plex reticle, 1/4 MOA clicks and parallax set at 50 yards. Neither has aim points for the other's job.

Can I use the Crossfire II crossbow scope on a rifle?

Vortex sells it for crossbows. Mechanically it's a 30mm scope, but the XBR-2 yardage marks are calibrated to crossbow arrow speeds from 275 to 450 fps, so they won't line up with a rifle bullet's drop. For a rimfire rifle, Vortex makes the Crossfire II 2-7x32 Rimfire, with parallax set at 50 yards.

What distance do you zero the Vortex Crossfire II crossbow scope?

Forty yards on the centre crosshair. Vortex suggests a first group at 6 yards, which on a typical trajectory lands close to the 40-yard zero, then a final sight-in at 40 yards at 7x. After that, set the magnification ring to your crossbow's speed and reindex the turrets so they read zero.

Do you need a receipt for the Vortex VIP warranty?

No. Vortex says you don't have to register the scope, save the box or keep a receipt, and that cover applies regardless of "where you purchased it." It promises repair or replacement at no charge for damage or defects, however they happened. It doesn't cover loss, theft, deliberate damage, or cosmetic damage that doesn't affect performance.

Equipment topics:CrossbowsBowhunting
Tags:vortex crossfire ii 2 7x32 reviewvortex crossfire ii 2 7x32vortex crossfire iicrossbow scopexbr-2 reticlecrossbowsreview
Simplified three-step diagram of a rangefinding crossbow scope: press the range button so a laser measures angle-compensated distance to a deer, the scope lights the aim point for that distance, and auto-calibration builds aim points out to 80 yards from a 20-yard sight-in, with a bar showing ranging to 250 yards is far beyond shooting rangeGear

Rangefinding Crossbow Scopes Explained

How a crossbow scope with a built-in rangefinder works: laser ranging, speed calibration, batteries in the cold, and why legality varies by state.

Updated October 6, 2026 · 4 min read